Posts Tagged ‘console’

Initial Cisco switch configuration

June 28, 2012

First steps you need to do when you unpack your Cisco switch, for example Catalyst 2960, are configuring passwords and IP access via telnet and ssh. Cisco networking switches and routers have two primary operation modes: User (unprivileged) and Enable (privileged). In User mode you can simply look around, but in Enable mode you can reboot a switch, change configuration info, as well as screw everything up. You are safe in User mode. Switch also has tons of hierarchical configuration modes where you perform actual configuration.

Switch has three passwords: two for User mode (for connection from serial console and for external telnet and ssh connections) and one for Enable mode. Here is how you configure passwords after you unpack your switch and connect the serial cable.

Enter configuration mode:

enable
configure terminal

Configure console password:

line console 0
password pass1
login
exit

Configure ssh and telnet password:

line vty 0 15
password pass2
login
exit

Configure Enable password:

enable secret pass3
exit

‘login’ command tells switch to ask for User mode password. It doesn’t do that by default. Switch has 16 virtual (ssh and telent) consoles, that is why you see ‘0 15’ range in ‘line vty 0 15’ command.

Now to get IP access to the switch you need to configure so-called ‘VLAN 1 interface’:

enable
configure terminal
interface vlan 1
ip address 192.168.1.200 255.255.255.0
no shutdown
exit

ip default-gateway 192.168.1.1
exit

VLANs are not subject of this topic. But to make it a bit more clear, VLAN 1 is a special VLAN where all switch ports are connected. It’s done so that you could connect to the switch by telnet/ssh from any port. ‘no shutdown’ command here brings interface up. It’s disabled by default.

After you’ve made an initial configuration, your changes are active but not saved. After a reload you will have empty switch configuration. To save the configuration changes run:

copy running-config startup-config

Cheers!

Advertisements

WSUS 3 snap-in in Windows XP

October 24, 2011

Same thing with WSUS snap-in. To add it into your MMC console you need to download full Windows Server Update Services 3 package from here and select only console during installation. Then you will find WSUS snap-in in MMC.